Safes

Fire Safes

I have forgotten my PIN code.

Please e-mail assistenzatecnica@assaabloy.it with the serial number & ID.

Note: The Consumer Help team cannot send a over ride master code.

Close
I cant get into my safe, the batteries are flat.

You will need a 9volt battery, the backup terminal is underneath the dial turn. When you first apply the battery, the keypad will illuminate and then go off. However, keep the battery help on and then swipe the keypad to re-illuminate and enter your PIN Code. Once the safe is open please replace the batteries.

Close
Will my code still be the same when batteries have exhausted?

Your code will remain the same until you go through the reset code procedure.

Close
The keypad flashes 3, 2, 1. What does this mean?

You have been locked out due to incorrect code. Please wait until the 3 minute countdown has expired and re-try.

Close
Can I wall or floor mount this safe?

You can only floor mount this safe, due to the fire-protective material inside.

Close

Certified Safes

Why the safe is not accepting my new code?

Please make sure you are completing the set code procedure until it displays 'good', remembering that if you have opened the safe with the key you also have to lock it with the key, from then on using the code as usual.

Close
Can I wall or floor mount this safe?

Four bolts are provided. You can either wall or floor mount this safe.

Close
Problem setting code, display says ‘ERROR’

First press and hold down the ‘ENTER’ and keep pressed down.
Whilst keeping ‘ENTER’ button pressed down, then press ‘3’, the ’SET CODE’ message will appear on the display.
Enter your new code and press the key symbol, you will be asked to repeat this.

Close

Premium Safes

The safe is not accepting my new code.

Please make sure you are completing the set code procedure until it displays 'good', remembering that if you have opened the safe with the key you also have to lock it with the key, from then on using the code as usual.

Close
Can I wall or floor mount this safe?

Four bolts are provided. You can either wall or floor mount this safe.

Close
Problem setting code, display says ‘ERROR’

First press and hold down the ‘ENTER’ and keep pressed down.
Whilst keeping ‘ENTER’ button pressed down, then press ‘3’, the ’SET CODE’ message will appear on the display.
Enter your new code and press the key symbol, you will be asked to repeat this.

Close

Value Safes

Where can I find the reset button to set/change my code?

This will be a red push button near the hinge or in the battery compartment at the top of safe.

Close
Can I wall or floor mount this safe?

Four bolts are provided. You can either wall or floor mount this safe.

Close

Products Documents

Did not find what you were looking for? Contact us here!